RoamerLite-D – The very unique Digital & Cordless LED illuminated map magnifier – AA Batteries Required

RoamerLite-D (Digital) is an evolution of the successful RoamerLite-C cordless LED-based map magnifier. RoamerLite-D (Digital) is the first map magnifier to go digital and cordless, featuring:

Preparation / How to use:

Unscrew the battery case cap and insert three AA batteries into the cartridge.

Re-assemble the battery case, noting that the screw cap locks the batteries into the case and

provides a very sturdy and waterproof seal.

The different colour LEDs will flash in sequence, twice, to show that the RoamerLite-D is

ready to go, and the unit will then show white LED illumination at a mid-brightness level.

Turning on/off and brightness

All functionality is controlled by the two push buttons, Red and Black.

To switch the unit on press and hold both buttons until the LEDs illuminate – the brightness and colour of the main LEDs (i.e. white or red) are remembered from when you last switched it off.

Choose a brightness level by simply pressing the Red button (up) or the Black button (down).

To switch the unit off press and hold both buttons briefly - the LEDs will turn off.

White/red LED selection

Continue to hold the Red button after maximum brightness is obtained and the LEDs will start to flash (at a mid-brightness level). If you continue to hold the Red button for about 2 seconds, the

RoamerLite-D will switch from the White LEDs to the Red LEDs (or the red LEDs to the white LEDs) at a mid-brightness level.

Change the brightness of the new colour by simply pressing Red button (up) or Black button down).

If you release the button before the 2 seconds expire, the LEDs will not change to the other colour.

Similarly, holding the Black button after minimum brightness will cause the LEDs to flash and continuing to hold it will change the LEDs to the other colour.

Emergency mode selection

With either the white or red LEDs illuminated, press and hold both buttons until the blue LED flashes, continue holding both buttons until the white LED’s flash. Releasing the buttons will leave the white LEDs flashing at maximum brightness in “attract mode” (the white LEDs showing a repeating pattern of three flashes on/off then a slight pause) allowing you use this mode to attract attention.)

If you then press either button, the flashing LEDs will toggle between the “attract” mode and the “SOS” mode

(the red LEDS showing a repeating pattern of “SOS” in Morse code).

“SOS” mode allows you to shine the flashing LEDs to attract attention and request assistance.

To turn an emergency mode off, press and hold both buttons briefly and the LEDs will turn off.

The next time you turn the unit on, by pressing and holding both buttons, it will return to normal white/red illumination mode.